I4c-T
Sound Isolating Earphones
These
WEARING THE EARPHONES
Wear the earphones as illustrated below.
INSERTING THE EARPHONES
If the earphone seems to be lacking in low frequency response (bass), check the tightness of the seal between the earphone and your ear, or try one of the other sleeve options.
Warning: Do not push the earphone sleeve beyond the ear canal opening.
right
left
©2005, Shure Incorporated | Printed in U.S.A. |
27EN3213 (Rev. 2) |
|
CHOOSING AN EARPHONE SLEEVE
Your earphones come with a selection of sleeves. Make sure the sleeve you use is easy to insert into your ear, fits comfortably, and is easy to remove from your ear.
Flex Sleeves
In small, medium, and large sizes. Made from translucent
PVC.
Soft Flex Sleeves
In small, medium, and large sizes. Made from pliable rubber.
Foam Sleeves
When using the foam sleeves, compress the sleeve between your fingers before inserting it into the ear canal. Hold the earphone in place for about ten seconds while the foam expands and creates a tight seal.
Triple-Flange Sleeves
If desired, the sleeve nozzle may be shortened. Use sharp scissors to carefully trim the nozzle to the desired length.
Over the ear
in front
INLINE SWITCH CONTROL
Push and hold to to MUTE cell phone microphone
Volume
Note: switching to media during a call mutes cell phone.
Make sure that the sleeve completely covers the earphone nozzle. If any part of the nozzle is exposed, the sleeve is not properly installed
CLEANING THE EARPHONE NOZZLE
If the nozzle of your earphone is blocked, clean the nozzle using the supplied wax removal loop.
Wax Removal Loop
Nozzle
When cleaning, do not force any object through the earphone nozzle! This will damage the earphone sound filter.
If necessary, the supplied replacement nozzles may be used. See the back of this guide for instructions on nozzle replacement.
