Caring for the Blender
Cleaning Instructions
WARNING:
Turn blender off and unplug power
cord before cleaning.
General cleaning
The machine housing contains electrical components. Do not wash it in a dishwash- er or immerse it in water. Do not use high pressure water spray to clean any part of the machine.
1.Do not allow food residue to dry on the machine. Wash and rinse jar after use.
To wash and rinse jar
1.Remove the container from the machine and remove the cover and dosing cup. Rinse the jar interior, cover, and dosing cup under running water.
2.Add the washing solution to the jar and scrub with a nonabrasive pad or cloth and flush out the interior, cover, and dosing cup to dislodge and remove as much food residue as possible. Empty jar.
2. Use a | WARNING: |
washing. Use hot (less than 115°F/46°C) | Cutter blades are sharp; to reduce |
water mixed with the amount of detergent | the risk of personal injury, use |
recommended by the detergent manufac- | caution when handling. |
turer. |
|
3.For rinsing, use warm (95°F/35°C) water.
4.For sanitizing, chlorine based sanitizing solutions with a chlorine concentration between
1 gallon (3.785 liters) of cold water
(4.93 ml) of institutional bleach (8.4% sodium hypochlorite content).
3.Wipe down jar exterior with a soft cloth or sponge dampened with washing solution. Wash the cover and dosing cup with fresh washing solution. Fill the jar 1⁄4 full with fresh washing solution, place on machine base, replace cover and dosing cup, and run on speed “5” for two minutes.
Empty jar.
4.Repeat step 3 using clean rinse water in place of washing solution.
NOTE:
Abrasive pads or cloths will
scratch the container jar and lid.
8