Shure PGXD manual Single System Setup, Multiple System Setup

Single System Setup

Scan		Synchronize
Use the scan feature on the receiver to		Synchronize the transmitter to the receiver by aligning the
find a clear channel.		infrared (IR) ports and pressing the sync button. Make sure
		the IR ports are closely aligned.
		After a successful sync, the transmitter LED momentarily
LED screen displays		flashes red and the receiver ready light illuminates.
current channel
	press channel
channel	button to scan for a
	clear channel

system scans for the channel

with the least interference

NOTE: This wireless system may be affected by RF inter- ference when used in proximity to other wireless devices such as cordless phones, baby monitors, and two-way ra- dios. For best results, use the scan and sync feature before each use or if you experience problems.

Multiple System Setup

Use the following steps to ensure the best performance when installing multiple wire- less systems at the same location.

1.Turn all receivers on and all transmitters off.

Note: Turn on any other digital equipment that could cause interference during the performance so it will be detected during the frequency scans in the following steps.

2.Make sure the group number is the same for all receivers (see Manual Group Selection).

3.Perform a scan using the first receiver.

4.Turn on the first transmitter and sync it to the receiver.

5.Repeat for each system.

•Important: After syncing each transmitter, leave it on so that scans from the other receivers will not select that channel.

•Be sure only one transmitter IR port is exposed when synchronizing each system.

Compatible Frequencies

When operating multiple systems simultaneously, choose one group from the following table and set all systems to different channels within that group.

Number of	Group (by band)
Systems
	X8	X8A	X8B (Brazil)
		(Austrailia)
2	3 to 9	3 to 9	3 to 9
3	3 to 9	3 to 9	3 to 9
4	3 to 9	--	3 to 9
5	7 to 9	--	--

4