SE110 | EARPHONES | |
Sound Isolating™ Earphones | ||
Balanced MicroSpeakers and a | ||
stylish sound isolating design to | ||
deliver a rich, lifelike listening | ||
THE | ||
experience, the Shure SE110 is | ||
an ideal portable listening device | ||
WEARING | ||
upgrade. An included modular cable | ||
and interchangeable Sound | ||
Isolating™ sleeves provide a | ||
comfortable, personalized | ||
fit. The carrying case further |
| |
enhances the portability of |
| |
these lightweight earphones. |
|
Suggested methods for wearing the earphones are | EARPHONESTHEINSERTING | If the earphone seems to be lacking in low frequency response (bass), | |
illustrated below. | check the tightness of the seal between the earphone and your ear, or | ||
| |||
|
| try one of the other sleeve options. | |
|
| Warning: Do not push the earphone sleeve beyond the ear canal opening. |
Over the ear in back
Cable
Over the earSleeve in front
Straight down
in front
To change earphone sleeve, twist and pull sleeve to remove it from the nozzle. Push new sleeve onto nozzle until you feel it slide completely over barb. If any part of the nozzle is exposed, sleeve is not properly installed. Replace sleeves if
they do not grip the nozzle tightly
©2007, Shure Incorporated | Printed in U.S.A. |
| |
27EN3254 (Rev. 2) |
| ||
|
| ||
REMOVING THE EARPHONESNozzle Barb | Grasp the body of earphone and gently twist to remove. | CHOOSING AN EARPHONE SLEEVE | |
|
|
Note: Do not pull on cable to remove earphone.
Tighten the cable and take up slack by raising the cable sleeve.
Your earphones come with a selection of sleeves. Make sure the sleeve | NOZZLE | If you notice a change in sound quality, remove the sleeve and check | |
you choose is easy to insert into your ear, fits comfortably, and is easy | the nozzle of your earphone. If nozzle is blocked, clear obstruction by | ||
| |||
to remove from your ear. | EARPHONE | using wire loop end of cleaning tool. | |
| Cleaning | ||
|
| ||
Soft Flex Sleeves |
| Tool | |
|
| ||
In small, medium, and large sizes. |
| Wire Loop | |
Made from pliable rubber. | THE |
| |
| Nozzle | ||
|
| ||
| CLEANING | Barb | |
Soft Foam Sleeves |
| ||
|
| ||
When using the foam sleeves, compress the sleeve |
|
| |
between your fingers before inserting it into the ear canal. |
|
| |
Hold the earphone in place for about ten seconds while the |
| Nozzle | |
foam expands and creates a tight seal. |
|
| |
Note: carefully slide sleeve over earphone nozzle barb for a secure grip. |
| When cleaning, do not force any object through the earphone | |
|
| ||
|
| nozzle! This will damage the earphone sound filter. | |
|
| Warning: The wax removal loop is only to be used to clean | |
|
| earphones. Any other use, such as using the tool to clean | |
|
| ears, could result in injury. |