Operating instructions | RDJ10 |
The RDJ10 is a room thermostat with a
Display
Introduction
This leaflet gives you
Contents
Commissioning
Initial
Setting the time
Setting the switch on and off times
Actual room temperature in ºC
The unit is controlling to the selected comfort temperature
The unit is controlling to the selected energy saving temperature
The unit is controlling to the selected frost protection temperature
Indicates when the temperature setpoint has been changed by the user. This setpoint will be maintained until the next switching time. This function is only active when the unit is in automatic mode.
Setting knob
Warmer/colder for selecting the temperature setpoint
Battery compartment
2 alkaline batteries type AA, 1.5 V
Operating mode selector
Automatic mode: The unit is controlling to the time and temperature programs that have been selected
Comfort mode: The unit is controlling continuously to the comfort temperature
Energy saving mode: The unit is controlling continuously to the energy saving temperature
Frost protection: The unit is controlling continuously to the frost protection temperature. This setpoint is fixed at 5 ºC
Advance button
Switches the operating mode from comfort to energy saving, or vice versa, until the next switching time
Indicates when there is demand for heat
Replace batteries
Frost protection: The unit is controlling continuously to the frost protection temperature
Energy saving mode: The unit is controlling continuously to the energy saving temperature
Comfort mode: The unit is controlling continuously to the comfort temperature
Automatic mode: The unit is controlling to the time and temperature programs that have been selected
Programming selector
|
|
|
|
| Time setting position |
|
|
|
|
|
|
|
|
A1 |
|
| First switch on time |
| ||
|
|
|
|
|
|
|
A2 |
|
| First switch off time |
| ||
|
|
|
|
|
|
|
A3 |
|
| Second switch on time |
| ||
|
|
|
|
|
|
|
A4 |
|
| Second switch off time |
| ||
|
|
|
|
|
|
|
|
|
|
|
| Comfort temperature setting |
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
| Energy saving temperature setting |
|
|
|
|
|
|
|
|
RUN |
|
| Set the controller to RUN when all |
| ||
|
| programming is completed |
| |||
|
|
|
|
|
| |
|
|
|
|
|
|
|
Setting the comfort temperature
Setting the energy saving temperature
Changing temporarily the current setpoint
What does the Advance button do?
Changing batteries
Energy savings tips
Commissioning
•Remove the black transit tabs from the alkaline batteries. Check to see if the battery holder is in its correct position
•If no batteries are inserted, fit 2 alkaline batteries type AA in the battery compartment
Initial power-up
Once batteries are fitted, all symbols will appear on the display as shown for about 2 seconds.
Setting the time
1.Set the programming selector to
position 
.The current time setting flashes.
2.Turn the setting knob to the left to decrease the time, or to the right to increase the time.
3.When the correct time is displayed, move the programming selector to any other position to confirm your setting.
CE1B3071en / 05.07.2007 | Subject to alteration | Siemens Building Technologies / HVAC Products |
