Siemens SC9000 Instructions for USE M Series Pivot Arm, Swivel, Tilt, Cable Management

INSTRUCTIONS FOR USE – M Series Pivot Arm

Pivot

1.To pivot the Arm (near the wall), simply push on the side of the Arm or mounted device.

2.To adjust the pivot tension at the Slide, use a ½” (or 13mm) socket driver to tighten or loosen the Pivot Tension Bolt to obtain the desired tension.

Pivot Arm

Swivel Tension Bolt

Pivot Tension Bolt

Swivel

1)To rotate the device simply push or pull the corners of the device.

2)To adjust the swivel tension, use a ½” (or 13mm) socket driver to tighten or loosen the Swivel Tension Adjustment Bolt located under the front end of the Arm.

Tilt

1.Grasp the top and bottom of the device and tilt it to the desired angle.

2.To adjust the overall tilt tension, evenly tighten or loosen the (2) #10-32 x 5/8” SHCS Tilt Tension Adjustment Screws using the supplied 5/32 (4 mm) hex key.

Cable Management

1.An open cavity beneath the arm with flexible cable covers manage cables going to and from the front and rear of the arm.

Flexible Cable Covers

DU-DR-0016-SC9000 Rev A 6/4/02 GCX Corp. Page 3 of 4