Sierra Wireless MP 595 7: Technical Specifications

7: Technical Specifications

This chapter provides technical data for the MP 595 modem.

Note: The technical specifications are subject to change without

notice.

Regulatory, radio frequency and

electrical specifications

Approvals FCC

Industry Canada

EU RoHS

Network compliance CDMA 1xEV-DO Revision A (IS-856-A)

CDMA 1xEV-DO Revision 0 (IS-856)

CDMA 1X (IS-2000)

CDMA IS-95A

Voltage range 9–36 VDC

Reverse polarity

protection Compliant

Current draw Max transmit (23 dBm output)a

Cellular: 375 mA

PCS: 395 mA

Typical transmit: 250 mA average

Receive: 215 mA

Idle (Ignition Sense off): 2 mA

Maximum output

power 23 dBm (200 mW)

Transmit PCS: 1850 to 1910 MHz

Cellular: 824 to 849 MHz

Receive PCS: 1930 to 1990 MHz

Cellular: 869 to 894 MHz

a. This applies to a typical installation with a well-matched antenna.

All current values are measured with an input voltage of 12 V.

Rev 1.3 Aug.07 59

Contents

Main Page Important Notice Safety and Hazards Limitation of Liability Patents Copyright QUALCOMM 3G Trademarks Contact Information Revision History Page Contents Page Page Page Page Page 1: Introducing the MP 595 Modem About CDMA CDMA account and coverage Supported CDMA radio frequencies Receive diversity USB, Ethernet, or serial computer connection Virtual serial port VPN support for RNAP Software Documentation Page Page 2: Hardware and Software Installation Installation overview Install the MP modem Package contents Required equipment System requirements MP Modem accessories Installation overview Install the MP modem Step 1Mount the MP modem Page Step 2Mount the antennas and install the cables Page Step 3Install the Power Harness Page Page Page Step 4Connect MP modem to computer cable to the MP modem Hardware and Software Installation Note: Ensure that the MP modem and your computer are powered off while installing cables. Rev 1.3 Aug.07 33 Install the USB, Ethernet or serial cable The serial connector uses these voltage specifications: Step 5Install the sof tware Step 6Activate your account Step 7Test the system Page 3: Operating the MP Modem Reading the status indicators 3G Watcher software Establishing connections Turning the MP modem on and off Reading the status indicators Resetting the MP modem 3G Watcher software 3G Watcher Help Launching 3G Watcher 3G Watcher window Establishing connections 4: Configuring the MP Modem to Report GPS and I/O Data GPS configuration and reporting I/O device installation and configuration GPS configuration and reporting GPS protocols and commands GPS display in 3G Watcher GPS TAIP quick reference I/O device installation and configuration Connector pinouts Digital input devices Digital output devices Analog input devices ~ I/O configuration using AT or 3G Watcher commands Page Page Page 5: Sending Data to Your Network Application Configuring the MP modem to route data to a server Retrieving the Unique Mobile Device ID Configuring the MP modem to route data to a server Report frequency timers Page Page Monitoring and Tracking configuration IP Addressing The problem created by Network Address Translation Retrieving the Unique Mobile Device ID 6: Support and Warranty Technical support Warranty Technical support Warra nty Page 7: Technical Specifications This chapter provides technical data for the MP 595 modem. Rev 1.3 Aug.07 59 Regulatory, radio frequency and electrical specifications Environmental specifications Weight and dimensions Technical Specifications Host interfaces Rev 1.3 Aug.07 61 Other interfaces GPS specifications I/O port characteristics 3G Watcher software 8: Regulatory Information Canada U.S.A. Canada U.S.A. Page Index Numerics A C D M N O P R