b) Concrete/Brick Installation
NOTE: The concrete anchors must be used for concrete installation.
1Begin by placing the wall plate into position against the wall, using the bubble level to keep it level.
2Mark four holes to be used for securing the mount and place the wall plate aside.
3Next, drill holes using an electric drill and 5/16" masonry bit to a depth of 2".
4Insert a concrete anchor into each hole.
5If necessary, a hammer can be used to lightly tap each anchor into place so that they are flush with the wall.
6Once all of the anchors are in place, move the wall plate back into position
7Insert bolt (J) with washer (L) into each concrete anchor in the wall.
8Do not tighten until all screws are in place.
Step 2 Display Bracket Installation
1To ensure optimal installation, this kit includes various screws of different diameters and lengths.
2Place your TV screen down on a soft, flat surface, and locate the threaded mounting points that are located on the back of the display.
3Determine which screw (A/B/C/D/E/F/G/H) is of the correct length by carefully inserting a straw, or toothpick, and mark how deep the mounting point is.
4If your display has a curved back or a recessed thread mounting point, a spacer (M) must be used. Then choose screw (F/G/H) to match.
5Place the spacer (M) between the mounting bracket and display.
6According to the size of display's hole, choose the corresponding screw and hole on the rectangle washer, then thread them in line as shown (figure
Step 3 Final Installation & Adjustment
1Hook the TV Rails over the top of the wall plate (figure
2Then rotate the long screw at the bottom of the display rail to tighten.
Maintenance
Check the mounting screws every two months for tightness.
4
