5.Slide the Dual 2.5" SATA MobileRack into the drive bay and secure it on each side using the mounting screws.
6.Connect a power cable to the power connector that is matched with your system's power supply or use the supplied power adapter cable.
7.Connect one end of the Serial ATA cable to the Dual 2.5" SATA MobileRack and the other end to the motherboard SATA port. Please repeat these steps if you are installing the second hard drive.
8.Close your computer case.
Installing the Hard Drive into the MobileRack
1.Unlock upper and lower covers, then open the door (see Figure 3 on the next page).
Note: Do not force the door to open while it is locked. Otherwise, you will damage the lock.
2.Place one or two hard drive(s) in the slot. Make sure the SATA connector is lined up with the connector inside the MobileRack.
3.Carefully push the hard drive into the MobileRack sothatthedrive'sSATAconnectorisseatedsecurely, then close the door and lock it.
Note: It must be in the lock position when in use. This prevents unexpected removal while working.
4
