SIIG 04-0600A manual Drywall Surfaces, ST5.5 c 45 Self Tapping Screw

ST5.5 c 45 Self

Tapping Screw

Figure 7

3.Drill holes through the drywall and into the wood stud using a 1/8" drill bit. These holes should be drilled 1-7/8" deep, see Figure 7 above.

4.After the holes are drilled, mount the wall plate using the self tapping screws.

Drywall Surfaces

1.Locate the best mounting location in the ceiling or wall. Using the wall plate as a template, mark the hole positions on the mounting surface. For in-wall applications,positionthemountingholesinavertical pattern, see Figure 8 on the next page.

2.Drill holes in the drywall using a 5/16" drill bit.

3.Once the holes are drilled, insert the alligator anchor into the holes. Make sure the anchor is flush with the wall and/or ceiling surface, see Figure 8 on the next page.

9