b) Concrete / Brick Installation
Note: The concrete anchors must be used for concrete and brick installation.
1Attach the bubble level
2Mark six holes to be used for securing the mount, and place the wall plate aside. Locate the holes directly into the block or concrete, never into the mortar between the blocks (Figure 4).
3Drill six holes using an electric drill and 1/2" masonry bit to a depth of 2" at the positions you marked.
4Insert a concrete anchor (G) into each hole.
5If necessary, a hammer can be used to lightly tap each concrete anchor into place so that they are flush with the wall.
6Once all of the concrete anchors are in place, move the wall plate back into position. Check the bubble level to verify that the wall plate is level.
7Insert bolts (H) and washers (J) into the concrete anchor as shown (Figure 4) and tighten. Do not fully tighten until all screws are in place.
Figure 4
Step 2 Display Plate Installation
Note: The installation kit includes screws of various diameters and lengths to ensure optimal installation.
1Place your TV screen down on a soft, flat surface, and locate the threaded mounting points that are located on the back of the display (Figure 5).
2Determine which screw (A/B/C/D/E/F) is of the correct length by carefully inserting a straw or toothpick, and mark how deep the mounting point is (Figure 6 &
3If your display has a curved back or a recessed thread mounting point, a spacer (K) must be used. Then choose screw (D/E/F) to match. Place the spacer (M) between the mounting bracket and display (Figure
4According to the size of display's hole, choose the corresponding screw (A/B/C/D/E/F) and hole on the rectangular washer (I), then thread them in line (Figure 6 & Figure
Figure 5 | Figure 6 | Figure |
|
|
|
4
