Silva TH52 installation manual Applications, Tools and Materials Needed

English DEPTH TH52

INSTALLATION INSTRUCTIONS

Thru-Hull Depth Transducer

Low Profile, Flush, and Retractable Models

IMPORTANT: Please read these instructions completely before proceeding with the installation. These directions supersede any other instructions in your instrument manual if they differ.

WARNING: NEVER USE SOLVENTS!

Certain cleaners, fuel, paints, sealants, and other products may contain strong solvents, such as acetone, which attack many plastics greatly reducing their strength.

1 Applications

•Plastic housing is recommended for fiberglass or metal hulls only. Never install a plastic thru-hull sensor in a wood hull, since swelling of the wood may overstress the plastic causing a fracture.

•Bronze housing is recommended for fiberglass or wood hulls only. Never install a bronze housing in a metal hull, because electrolytic corrosion will occur.

•Stainless steel housing is recommended for metal hulls to prevent electrolytic corrosion.

•Never install a metal housing in a vessel with a positive ground system.

2 Tools and Materials Needed

Safety goggles Dust mask

Electric drill with 10mm (3/8") or larger chuck capacity Drill bit: 3mm or 1/8"

Hole saw (see table on page 1)

Beveled countersink tool for B21, P269, and P314 Countersink tool for B119, P217, and P219 Sandpaper

Mild household detergent or weak solvent (alcohol) File (installation in a metal hull)

Marine sealant

Additional washer for some aluminum installations Slip-joint pliers for metal housing

Silicone grease or petroleum jelly (Vaseline ® ) (retractable units) Zip-ties

Water-based antifouling paint (mandatory in salt water) Installation in a cored fiberglass hull:

Hole saw for hull interior: (see table on page 1) Fiberglass cloth and resin (see page 4, #5)

or Cylinder, wax, tape, and casting epoxy (see page 4, #5)

11-4