Tips:
1.Per timer memory slot a maximum of 14 buttons can be programmed. After entry of the 14th button the sequence will be automatically saved and "FULL" is shown in the LCD display q.
2.In this menu also the device will return to the standard dis- play after approx. 15 seconds without an entry.
Learn Setup
The Universal remote control (URC) can learn and save but- ton signals of an original remote control. If the URC does not work after applying the programming methods already de- scribed or cannot carry out all commands please attempt to teach the URC with the help of the original remote control.
•Use new batteries for the URC and the original remote control.
•Maintain a distance of at least one metre from other light sources. The light sources could disrupt the infrared trans- mission.
•Place the URC and the original remote control at a dis- tance of 20 to 50 mm from each other on an even surface so that the infrared diodes 1( are facing each other.
Tips:
1.Do not use the following buttons for the learn function: all device buttons e, MACRO i, S button r, EXIT y.
2.When teaching please do not release the button of the original remote control until "SUCCESS" or "LEARN ERROR" appears in the LCD display q.
3.If when teaching, during the notice "LEARNING", no button is pressed on the original RC after 25 seconds the learn menu will end. This mode can not be ended
by pressing a button on the URC.
4.If the memory is full the LCD display q shows "LEARN FULL" and the learn mode will end.
5.With the EXIT button y you return to the previous status (except with a notice of "LEARN KEY" and/or "LEARN- ING").
Code learn function
1.Press the device button e for the device that the URC should learn a button code.
2.Hold down the S button r for a little longer than 3 sec- onds. The notice "CODE SETUP" appears.
3.With the or button t select the menu "LEARN SETUP" and then press the OK button k.
4.In the LCD display q "LEARN SET" appears. Then press the OK button k. In the LCD display q "LEARN KEY" ap- pears.
- 17 -
