Faults / Remedies
Your device does not react to the URC.
>> Check the batteries. They must have enough voltage and be properly installed.
>> Firstly have you pressed the correct device button e for the desired target device?
>> Check to see that the correct code is programmed in for the target device (see section "Code Setup").
The URC is transmitting the commands incorrectly.
>> Press the corresponding device button e to set the URC to the correct mode.
>> The batteries must have enough voltage and be properly installed.
>> It is possible that you are using the wrong code. Start the brand code search, the automatic code search or the di- rect code input (manual).
The URC does not change the station on the device.
>> Press the corresponding device button e to set the URC to the correct mode.
>> In the event that the original RC does not have a
>> If this also does not work the child protection for the target device could be activated.
Some buttons on the URC do not function properly.
>> It is possible that your URC does not have all of the func- tions that are on the device's original remote control.
>> It is possible that you have not programmed in the optimal code. Search for a code that supports more of the target device's functions.
The URC stops reacting after a button is pressed.
>> The batteries must have enough voltage and be properly installed.
>> Point the URC towards your device.
The LCD display q shows nothing.
>> The batteries must have enough voltage and be properly installed.
>> The contrast could be set too low. Increase the contrast setting.
- 23 -
