Silvercrest SDRB 1000 A16 Attaching/detaching the brush attachment, Steam brush function

•Close the water fill opening 2 to the water tank 1. Ensure that the lug on the water fill opening 2 sits in the indentation on the lid. Only in this way is the water tank 1 properly closed.

•Replace the water tank 1 back onto the appliance. The water tank 1 must audibly engage with the unlocking device for the water tank 4.

Attaching/detaching the brush attachment

Attention!

NEVER attempt to attach or detach the brush attach- ment w when the appliance is heated up. Risk of Burns!

•To use the steam and brush function, place the brush attachment w onto the steam brush.

•To do this, slide the brush attachment w all the way along the guide to the end. The unlocking device of the brush attachment q must engage audibly.

•To be able to use the ironing function, remove the brush attachment w from the steam brush.

•To do this, press the unlocking device q down- wards and, at the same time, pull the brush attach- ment w away to the front.

Steam brush function

•Place the brush attachment w onto the applian- ce. This must engage audibly with the unlocking device on the brush attachment q.

•Insert the power plug 7 into a correctly installed and earthed mains power socket.

•Position the temperature regulator 3 at •••.

The heating-up control lamp 5 glows. As soon as the set temperature has been reached, the hea- ting-up control lamp 5 goes out.

Information

When using the steam blast function, always place the temperature regulator 3 at the position ••• . At lower settings the temperature is not sufficient to generate a steam blast.

•By pressing the steam blast button 8 you can now produce jets of steam.

The appliance is now ready for use.

Notice:

To release the first steam blast after heating the appliance up, it can happen that you may need to press the steam blast button 8 several times in succession.

Attention!

The steam brush can be used with all clothing items. Caution is to be exercised with heat-sensitive materials such as synthetics, polyamides or artificial silk. With these materials you should first check at a concealed part (inside seam) that the hot steam will not cause any damage to the garment. Do not touch these ma- terials directly with the hot sole of the iron 0. Use only the steam blast.

Clothing care

•Suspend the crumpled garment from a coat hanger.

•With one hand pull the garment flat, then steam it from top to bottom. The combination of steam and clothes brush r will gently remove all creases.

•Use light pressure with the clothes brush r and guide the appliance from top to bottom over the garment. You can thereby press the steam blast button 8 in short intervals.

Notice:

You can repeatedly press the steam blast button 8 until the heating-up control lamp 5 glows or water drips from the sole of the iron 0.

Then, wait until the heating-up control lamp 5 extin- guishes before activating a further blast of steam.

•Should the heating-up control lamp 5 start to glow during the process, release the steam blast button 8 and wait a few seconds until the heating-up control lamp 5 extinguishes.

- 5 -