Warning:
If the control lamp i does not go out after 10 seconds at the latest, the appliance is defective! Immediately remove the plug from the wall socket. Do not attempt to repair the appliance yourself. In this case, contact Customer Services.
➩Open the appliance cover u again and remove the film. This is sealed at one end and, at the same time, separated from the roll of tube film. Seal the remaining open sides, except for one, in the same manner.
➩Fill the bag. You must leave at least 6 cm of the bag free, measured up to the edge that is to be sealed.
➩Place the open end of the bag around the extraction supports w. For this you can lift them lightly. Thereby, the bag must project to the markings in the appliance.
Warning:
Fill the bags in such a way that, under no circum- stances, food remnants or fluids can run out of the bag when sealing it and permeate into the appliance.
➩If you do not want to extract the air from the bag, you should now seal the last open side.
Vacuuming films
When sealing, you can at the same time extract the air from the bag (vacuuming):
Warning:
Do NOT vacuum bags in which there are liquids. They will permeate into the appliance and damage it.
Note:
The bag opening must sit smoothly on the extraction supports w, the sealing wire r and the cutting wire e. Otherwise, the vacuuming, sealing and cutting will not function properly.
➩Close the appliance cover u and firmly press it down on both sides. Be sure not to press on the Seal/Cut button y. Air is now sucked from the bag.
- 5 -
