Utilisation
Sealing the film
Attention:
For sealing use only films rated HDPE (High Density PolyEthylene) or LDPE (Low Density PolyEthylene). The film thickness must be 30 - 50 μ (0.03 - 0.05 mm). Otherwise, the sealing seam will not be tight and the appliance could be damaged. You will recognise films of this type by the information on the packaging.
The quality of the seal joint varies depending on the type and strength of the film.
Attention:
Do not heat the supplied film, for example in a water- bath or similar. It is construed for temperatures of a maximum of 60°C.
➩Fold the appliance cover u up.
➩Pull out as much film as is required for the task at hand.
➩Then close the appliance cover u.
➩Firmly press the appliance cover u down.
Note:
The bag opening must sit smoothly on the sealing wire r and on the cutting wire e. Otherwise, the sealing and cutting will not function properly.
➩Press and hold the Seal/Cut button y with both hands until the control lamp i lights up. Hold the Seal/Cut button y pressed down until the control lamp down i goes out.
Note: |
To achieve the best results, press the Seal/Cut but- ton y down continuously, applying an even pres- sure and using both hands.
- 4 -
