Operation

Using aroma and herb containers

 

 

 

Prepare the facial sauna as described under “Preparing the facial sauna for use”.

Press once on the LO/HI/OFF button 8. The control lamp 7 glows green (low steam level "LO"). The water in the water bowl 6 is heated just sufficiently to produce a small amount of steam. For more steam, press on the LO/HI/OFF button 8 once more. The control lamp 7 glows red (high steam level "HI"). The water is heated more strongly and so produces more steam.

Hold your face over the face mask 1. Close your eyes and relax.

Attention!

Should you feel uncomfortable or perceive the steam as unpleasant, either hold your face a little further away from the face mask 1 or reduce the volume of steam. Should the feeling of discomfort continue, terminate the utilisation.

You can additionally regulate the steam volume as follows:

Slide the handle 5 of the steam regulator 4 to the right (in the direction MAX) to increase the steam volume. Slide the handle 5 of the steam regulator 4 to the left (in the direction MIN) to decrease the steam volume.

When the water in the water bowl 6 has eva- porated, the appliance switches itself off auto- matically. If you wish to switch the appliance off prematurely, press the LO/HI/OFF button 8 repe- atedly until the control lamp 7 extinguishes.

Note:

After 30 minutes the appliance switches itself off automatically, even if there is still water in the water bowl 6.

You can enrich the steam with various herbs and aromas. This can contribute to both relaxation and the treatment of the skin.

Important:

Only those types of herbs and aromas can be em- ployed that are intended and suitable for use in a facial sauna.

Before connecting the face mask 1 with the heating unit 9:

Press both locking devices on the lid 2 of the aro- ma and herb container 3 together and take from it the aroma and herb container 3.

Place either the herbs or a cotton wool ball sprinkled with aroma-essence into the aroma and herb container 3.

Press both locking devices on the lid 2 of the aro- ma and herb container 3 together and replace it on the aroma and herb container 3. Release the locking devices so that the lid 2 sits firmly.

Now assemble the face mask 1 on the heating unit 9 as described under “Preparing the facial sauna for use”.

The rising steam will now be directed through the aroma and herb container 3 and thus takes on the fragrance.

- 4 -

Page 6
Image 6
Silvercrest SGS 100 A1 operating instructions Operation, You can additionally regulate the steam volume as follows