2.Lean the appliance back a little and secure it so that it is safe. Completely unscrew and remove the front adjustable feet. Before you commence the next step, make preparations to prevent the appliance door from falling down. Remove the screws holding the lower door hinge and take the hinge off (Fig. 2). Replace the screws back into the holes on the freezer.
Fig. 2
3.Now lay the door to the side.
4.Unscrew the nut of the lower door hinge off and remove the axle. Fit the axle on the other side. Now rescrew the nut tightly firmly back on the axle (Fig. 3).
Fig. 3
5.You now have to reassemble the components on the opposite side. For this, unscrew the screws from the
6.Unscrew the axle of the upper door hinge. Turn the hinge around through 180 ° on its longitudinal axis and rescrew the axle back in (Fig. 4).
Fig. 4
7.Remove the white cap on the door bottom that covers the hole for the axis of the hinge. Replace the white cap in the now no longer needed hole.
8.Now position the door on the axis of the lower hinge. Remove the screws for the top hinge from the holes on the opposite side of the freezer and screw the top hinge back on with the help of these screws, but not yet firmly.
9.Now check the horizontal and vertical alignment of the door. Ensure that the sealing of the door sits firmly against its counterpart on the housing. First then do you secure all screws hand tight.
10.Now replace the upper appliance cover and screw it down tightly using the corresponding screws. Refit the temperature controller on the axle so that it is firmly seated.
Troubleshooting
Should the problems or malfunctions described in the following occur in the operation of your appliance, please first try to resolve the problem by means of this checklist. If this does not help, please contact our Service Hotline.
- 10 -
