MOON Aurora
Operating the Aurora
We recommend that you leave your MOON Aurora
Turning on your MOON Aurora for the first time
Prior to turning the amplifier on for the first time, make sure that every cable is properly connected to avoid any problems. Then, turn on your preamplifier/processor connected to the Aurora. Finally, power up your Aurora in the following manner:
1)Flick the main rocker switch labeled “POWER” to the ‘1’ (on) position
2)Next, momentarily press the push button labeled “Standby” located on the front panel. The amplifier will make a faint click sound, confirming that everything is in order. The blue LED on the front panel indicates the that the amplifier is powered up and ready for use.
On and Off Sequence
To avoid having any annoying noises (i.e. “thumps” and “pops”) emanate from your speakers when powering your Aurora on or off, you should:
1)Always power up your preamp/processor prior to powering up your Aurora
2)Always power down your Aurora prior to your powering down your preamp/processor
Using the 12 Volt Trigger
When the Aurora is off, it can be powered on by either the trigger or the push button. When the Aurora is on, it can be powered off by the trigger. It can also be powered off using the push button, but only if the trigger isn’t in «on» mode. The “MAIN POWER” switch must remain in the “on” position (“1”) at all times for the 12 V trigger to function.
Troubleshooting
Your MOON Aurora
If your Aurora still doesn’t power up, turn off the main power switch and check the AC fuse. If the fuse appears OK, put it back in its socket and then try to power up again the usual way. If the fuse is blown, replace it with a fuse of the same rating, and repeat the above process. At this point, you should be able to power up your Aurora. If not, immediately consult your dealer for assistance.
____________________________________________________________________________________
Operating the Aurora | 7 |