MOON P 5.3 Stereo Preamplifier
Balanced Operation
When using an unbalanced interconnect, the audio signal runs through both the center wire and the shield/ground wire. Any noise picked up by this interconnect (ie. nearby magnetic fields such as an AC power cord) will be reproduced by both the preamplifier and amplifier, then heard through the loudspeakers. Conversely, a balanced interconnect has three separate conductors; one for the ground and two for the actual signal. These two signals are identical except that one is 180 degrees out of phase with the other. For example, when one conductor is carrying a signal of +10 Volts, the other will be carrying a signal of
Remote Control Operation
The MOON P5.3 stereo preamplifier uses the
The
To operate the P5.3 with this remote control, you must first press the button labeled ‘Preamp’ in the top right corner.
The POWER button switches the P5.3 between ‘Standby’ and ‘On’ mode.
The INPUT button temporarily assigns the and buttons to perform the same function as the “+” and
The VOL+ and VOL– buttons increase and decrease, respectively, the volume level.
The and buttons control channel balance; Pressing the left arrow button causes a decrease in the volume level of the right channel; pressing the right arrow button causes a decrease in the volume level of the right channel.
The MUTE button, located in the middle of the volume and balance buttons, performs the identical function as the ‘Mute’ button located on the P5.3’s front panel.
Figure 4:
____________________________________________________________________________________
Remote Control Operation | 13 |