Installation

Installing Zeus SSDs

 

 

3.3INSTALLING ZEUS SSDS

To install the Zeus SSD in a personal computer (PC) or host system, complete the following steps:

1Power down the computer and remove the access cover.

2Configure the Zeus SSD as the master or slave device in accordance with the information provided in “Drive Configuration” on page 27.

3Connect one end of an ATA (IDE) cable to the Zeus SSD and the other end of the cable to the IDE adapter on the host. Orient the cable so that pin 1 on the Zeus SSD connects to pin 1 on the host adapter.

ATA standards require 80-conductor cables to be used for Ultra DMA modes 3 through 5. The length of the cable shall not exceed 18 inches.

4If installing a 3.5-inch SSD, connect a power cable from the computer’s power source to the 4-pin power connector located on the rear of the SSD.

5Position the Zeus SSD in an unused drive bay and secure it in place using six (6) machine screws. Apply sufficient torque to ensure that the drive is secure.

6Replace the access cover and power on the computer.

3.3.1Formatting Zeus SSDs for Windows, Linux and Other OS Environments

After installing the Zeus SSD (see section “Installing Zeus SSDs” on page 30), it is ready for use. Zeus SSDs do not require special driver installation, adjustments or modifications.

Zeus SSDs are low-level formatted at the factory. However, the SSD must be partitioned and high-level formatted.

3.4UPGRADING ZEUS SSD FIRMWARE

The firmware on the Zeus SSD is field upgradeable.

30

Zeus Ultra DMA Solid State Drives