Drive Configuration

Installation

 

 

3.2.2Configuring 3.5-inch Form Factor Zeus SSD

Zeus SSDs conforming to the 3.5-inch form factor, use a 40-pin ATA bus/DC power combination connector. To configure the SSD as either the Master or Slave device, place a jumper across the appropriate pins (1 - 8) as illustrated in Figure 6 on page 29.

In systems with multiple drives, it may be necessary to configure disk storage in a Master/Slave configuration. To accomplish this, boot the computer using IDE HDD Auto Detection available in the CMOS setup.

Figure 6. Master/Slave Setting for 3.5-inch Zeus SSDs

Zeus Ultra DMA Solid State Drives

29