Installation

Drive Configuration

 

 

3.2.1Configuring 2.5-inch Form Factor Zeus SSD

Zeus SSDs conforming to the 2.5-inch form factor, use a 44-pin ATA bus connector. To configure the SSD as either the Master or Slave device, place a jumper across the appropriate pins (A - D) as illustrated in Figure 5 on page 28.

In systems with multiple drives, it may be necessary to configure disk storage in a Master/Slave configuration. To accomplish this, boot the computer using IDE HDD Auto Detection available in the CMOS setup.

Figure 5. Master/Slave Setting for 2.5-inch Zeus SSDs

28

Zeus Ultra DMA Solid State Drives