Adjustments
Front-To-Back Levelling
1.Make sure mower is level
2.Position blade(s)
On 30” mower, the front tip should be level to 1/8” (3 mm) higher than rear tip.
On 34” mower, the front tips should be 1/4” (6 mm) higher than the rear tips.
3.See figure 33. Loosen jam nut (E). To lower rear of mower deck, loosen nut (B) which will lengthen level- ing rod (D). To raise rear of deck, shorten leveling rod
(D). When proper measurement is obtained, tighten nut (A) against bracket, then tighten jam nut (E) against nut (A).
Transport Height Adjustment
Transport height should be adjusted so that rear mower rollers are 1/8” - 1/4”
See figure 34.
1.Park rider on a flat level surface.
2.Adjust
3.Loosen nut (C) and position spacer (A) against rear trailing arms (D). Position both the left and right side spacers against trailing arms.
4.Tighten nut (C) securely.
5.Place mower lift lever in transport position. Rear mower rollers should be 1/8” - 1/4” off ground. If not, repeat steps 2 - 4.
Blade Brake Adjustment
Mower blades and mower drive belt should come to a complete stop within five seconds after electric PTO switch is turned off.
1.With riderin neutral, PTO disengaged and operator in seat, start the riderengine.
2.Look over the
3.If mower drive belt does not stop within five seconds, see your dealer.
*2397
Figure 33.
A. | Adjustment Nut | D. | Levelling Rod |
B. | Rear Nut | E. | Jam Nut |
C. | Bracket |
|
|
*2397
Figure 34. Transport Height Adjustment
A. | Spacers | C. | Nut |
B. | Rear Mower Rollers | D. | Rear Trailing Arms |
28