Auger Drive and Impeller
NOTE: Unless noted otherwise, use the standard hardware torque specification chart.
Torque to
9 - 11
1 | Hub of pulley to |
| face of auger. |
2
13
Apply a bead of gasket eliminator into rear seal groove and flat surface just past groove (Ref. 15 & 20).
9
3 |
4 |
5 |
6 |
7
3 |
2 |
14 |
15 |
16 |
17 | 11 |
|
18 | 12 |
19 |
23 |
Torque (Ref. 2) to 9 - 11
10 | 8 |
Locate pulley on worm shaft (Ref. 10) so the belt is 1.94" from rear of impeller housing.
3 |
|
17 | 20 |
21
Torque to
9 - 11
13
22
23
Auger stamped "R".
26 | 27 |
|
27 |
26 |
25 |
24 |
30 |
31 |
Auger stamped "L".
28 |
29 |
28 |
29 |
Place 1 or 2 washers as required.
The above parts group applies to the following Mfg. Nos.:
1692680 | 555M, 5HP Manual Start | 1693161 | 555M, 5HP Manual Start | 1693164 | 755M, 7HP Manual Start (Exp.) |
1692681 | 755E, 7HP Electric Start | 1693162 | 755E, 7HP Electric Start | 1693425 | 555M, 5HP Manual Start |
1692746 | 755M, 7HP Manual Start (Exp.) | 1693163 | 555M, 5HP Manual Start (Exp.) |
| Continued on next page |
© Copyright 1999 Simplicity Manufacturing, Inc. All Rights Reserved. | 14 | |
|