Traction Drive
NOTE: Unless noted otherwise, use the standard hardware torque specification chart.
1 |
10
11
9
12
13
Inside of frame.
14 | 15 |
17 |
16 | 18 |
|
13 | 3 |
| Apply loctite |
| & torque to |
| 55 - 60 |
2
Pack groove with grease.
Coat with Protectokote or rust preventive oil.
12 |
| 4 |
6 | 7 |
8 |
Remove all play out of axle by moving axle to left, move set collar (Ref. 27) to the right to take all play out of sprocket assembly (Ref. 29) and tighten. Befiore making this adjustment be sure tie bar support (see Frame Group) is installed between frame sides.
33 34
2835
Torque to
18 - 21
32 |
28 |
27 | Torque to | 19 |
| 10 - 14 | |
| 20 | |
|
| |
| 29 | 19 |
| Tighten when all parts | |
|
| |
|
| are tight against |
|
| shoulder of hub. |
| 39 |
|
38 | Apply | |
| to both ends. |
|
36 |
| 40 |
37 |
| |
|
|
41 |
21 |
13 |
|
|
| 5 | |
|
|
| 12 | |
|
|
| 9 | |
22 | 23 |
| 24 | |
|
| 26 | ||
30 |
|
| ||
11 | 10 | 25 | ||
| ||||
|
|
Inside of
frame.Apply locktite & torque to 8 - 10 ft. lbs.
31 |
Flat side toward bearing.
41 | 42 |
|
43
Earred end
With hub (Ref. 32) away from pivot arm assembly (Ref. 35), tighten so that drive disk (Ref. 39) has no play, but will freely rotate.
44 |
45 |
46 |
Bell crank must pivot freely.
The above parts group applies to the following Mfg. Nos.:
1692680 | 555M, 5HP Manual Start | 1693161 | 555M, 5HP Manual Start | 1693164 | 755M, 7HP Manual Start (Exp.) |
1692681 | 755E, 7HP Electric Start | 1693162 | 755E, 7HP Electric Start | 1693425 | 555M, 5HP Manual Start |
1692746 | 755M, 7HP Manual Start (Exp.) | 1693163 | 555M, 5HP Manual Start (Exp.) |
| Continued on next page |
© Copyright 1999 Simplicity Manufacturing, Inc. All Rights Reserved. | 18 | |
|