FUEL AND OIL MIXTURE

The snowthrower uses a two cycle engine that requires a mixture of fuel (gasoline) and oil for lubrication of engine bearings and other moving parts.

The correct fuel/oil mixture ratio for the five horsepower engine is 50 to 1. Use fuel/oil mixture chart shown.

NOTE: To prevent damage to engine, carefully observe recommended fuel to oil mixing ratio and procedures.

Gasoline and oil must be premixed in a clean fuel container.

Always use fresh, unleaded, winter grade fuel

Never put plain, unmixed fuel into fuel tank. Shake fuel container each time before filling fuel tank.

Never use “stale” fuel left over from last season or stored for long periods.

DO NOT USE MULTI VISCOSITY OILS, SUCH AS 10W-30 or 10W-40.

Controls & Operation

FUEL TO OIL MIXTURE CHART (50:1)

U.S.

Imperial

Metric

Gasoline 2 Cycle Oil Gasoline 2 Cycle Oil Gasoline 2 Cycle Oil

Gallons

Ounces

Gallons

Ounces

Liters

Milliliters

1

2.5

1

2.8

4

80 ml

2

5

2

5.6

8

160 ml

5

13

5

14.1

20

400 ml

WARNING

Gasoline is highly flammable and must be handled with care. Never fill the tank when the engine is hot or running. Always move outdoors to fill the tank. Keep snowthrower and gasoline away from open flame or spark.

PROPER FUEL MIXING PROCEDURE

1.Fill approved clean fuel container one quarter full with fresh unleaded fuel - one quart (one liter) in a one gallon (4 liter) container.

2.Pour recommended amount of high quality two cycle oil — 2.5 ounces (80 ml) into fuel container for one gallon (4 liters) of fuel. (NOTE: DO NOT USE

MULTI VISCOSITY OILS, SUCH AS 10W-30 or 10W-40.)

3.Reinstall cap on the fuel container and shake con- tainer vigorously so oil mixes with gasoline.

4.Unscrew cap and fill container with fuel. Shake con- tainer again.

5.Remove fuel tank cap and carefully pour mixed fuel into the fuel tank, filling to 1/2 inch (1.5 cm) below filler neck to allow room for expansion. Never put plain, unmixed fuel into fuel tank. Shake fuel con- tainer each time before filling fuel tank.

A BCD

Figure 6. Proper Fuel Mixing Procedure

A.Fill Container with 1 Quart (1 Liter) of fuel

B.2.5 Ounces (80 ml) of two-cycle oil

C.Combine in container, then shake container

D.Additional fuel brings total to 1 Gallon (4 liters)

9

Page 13
Image 13
Simplicity 1693166 Fuel and OIL Mixture, Proper Fuel Mixing Procedure, Multi Viscosity OILS, Such AS 10W-30 or 10W-40