4.On hydro model, release the parking brake by depressing the brake pedal (H, Figure l), then press down on either pedal (I or J, Figure 1) for the desired direction and speed of travel.
On gear model, fully depress clutch/brake pedal (H, Figure 2) to release the parking brake and disengage the clutch. Use the gear selector (I, Figure 2) to select the gear best suited for conditions, then slowly release clutch/brake pedal to engage clutch and start tractor in motion.
STOPPING THE TRACTOR
1.On hydro model, gradually take your foot off the ped- als (I & J, Figure 1) to make a smooth stop. To make a more rapid stop, depress the brake pedal (H, Figure 1).
On gear model, press the clutch/brake pedal (H, Figure 2) down only far enough to disengage the clutch to make a gradual stop. For a more rapid stop, press pedal down fully to apply the brake.
2.Engage the parking brake by pulling up on the knob (C, Figure 1 & 2) with the brake pedal fully depressed.
3.Disengage the PTO by pushing down on the switch (F, Figures 1 & 2).
4.Set engine throttle control to
NOTE: Stopping the engine at any speed other than mid- throttle can cause engine damage. Do not stop the engine with the throttle control in the IDLE position.
Operation
PUSHING THE TRACTOR BY HAND
Towing the tractor will cause transmission damage. Do not use another vehicle to push
Hydro Models
1.With engine off and key removed, disengage the PTO by pushing the switch (F, Figures 1 & 2) all the way down.
2.See Figure 4. The release lever is located on the rear of the tractor. To release the transmission pull the lever up, back and then down to lock. DO NOT ACTIVATE WHILE ENGINE IS RUNNING.
Note: To drive the tractor the release lever most be moved completely forward and pushed down into locked position to engage the transmission.
Before leaving the operator’s position for any reason, engage the parking brake, disengage the PTO, stop the engine and remove the key.
To reduce fire hazard keep the engine tractor v”“” and mower free of grass, leaves and excess
grease. Do not stop or park tractor over dry leaves, grass or combustible mate$als.
Figure 4. Release Lever - Hydro Models
1.With engine off and key removed, disengage the PTO by pushing the switch (F, Figures 1 & 2) all the
2.Place the gear selector in the NEUTRAL position.
3. ~~~~~~rking brake.
