STARTING AND STOPPING THE ENGINE
To Start Engine:
1.Drive control levers should be released to neutral position.
2.Turn fuel
3.Push choke lever to choke position.
4.Move throttle control lever to fast position.
5.Push rocker switch (if equipped) to on.
6.Pull start engine. Stand to the right of tiller engine, grasp rope handle and pull rope out, slowly, until it pulls slightly harder. Let rope rewind slowly.Then pull rope with a rapid full arm stroke. Let rope return to starter slowly. Let engine warm for a few minutes before beginning to operate.
7.When engine starts, operate in fast position.
8.Move choke lever toward run position.
NOTE: If engine does not start after 3 pulls, check troubleshooting guide for suggestions.
To Stop Engine:
1.Move throttle control to slow position. Then move to stop position.
2.Push rocker switch (if equipped) to off.
3.Close fuel
Refer to your engine manual for further information.
Operation
CAUTION
Always keep hands and feet clear of rotating machine parts.
CAUTION
Temperature of muffler and near by areas may exceed 150° F. Avoid these areas.
CAUTION
Do not move choke lever to CHOKE to stop engine. Backfire or engine damage may occur.
To stop the engine at any time, move throttle control to the off position. To stop wheels and tines at any time, release drive control levers to neutral position.
Page 13
