Simplicity 250 Z Troubleshooting The Rider, Troubleshooting, Adjustments, & Service, Problem

Troubleshooting, Adjustments, & Service

TROUBLESHOOTING

While normal care and regular maintenance will extend the life of your equipment, prolonged or constant use may eventually require that service be performed to allow it to continue operating properly.

The troubleshooting guide below lists the most common problems, their causes and remedies.

See the information on the following pages for instruc- tions on how to perform most of these minor adjustments and service repairs yourself. If you prefer, all of these procedures can be performed for you by your local authorized dealer.

WARNING

To avoid serious injury, perform maintenance on the rider or mower only when the engine is stopped and the parking brake engaged. Always remove the ignition key, disconnect the spark plug wire and fasten it away from the plug before beginning the maintenance, to prevent accidental starting of the engine.

TROUBLESHOOTING THE RIDER

PROBLEM	CAUSE		REMEDY
Engine will not turnover or start.	1.	Motion control levers not	1. Lock motion control levers in neutral
		in neutral lock positions.	lock positions.
	2.	PTO (electric clutch) switch	2. Place in OFF position.
		in ON position.
	3.	Out of fuel.	3. If engine is hot, allow it to cool, then refill
			the fuel tank.
	4.	Fuel valve closed.	4. Open fuel valve.
	5.	Engine flooded.	5. Open the choke.
	6.	Gas is old or stale.	6. Drain fuel & replace with fresh fuel.
	7.	Battery terminals require	7. Clean the battery terminals.
		cleaning.
	8.	Battery discharged or dead.	8. Recharge or replace.
	9.	Wiring loose or broken.	9. Visually check wiring & replace broken or
			frayed wires. Tighten loose connections.
	10.	Solenoid or starter motor faulty.	10. Repair or replace. See authorized dealer
	11.	Safety interlock switch	11. Replace as needed. See authorized
		faulty.	service dealer.
	12.	Spark plug(s) faulty, fouled	12. Clean and gap or replace.
		or incorrectly gapped.	See engine manual.
	13.	Water in fuel.	13. Drain fuel & refill with fresh fuel.
	14.	Fuse(s) blown.	14. Replace blown fuse(s).
Engine starts hard or runs poorly.	1.	Fuel mixture too rich.	1. Clean air filter. Check the choke.
	2.	Spark plug faulty, fouled, or	2. Clean and gap or replace.
		incorrectly gapped.	(See engine manual.)
	3.	Fuel filter dirty.	3. Replace fuel filter.
Engine knocks.	1.	Low oil level.	1. Check/add oil as required.
	2.	Using wrong grade oil.	2. See engine manual.
Excessive oil consumption.	1.	Engine running too hot.	1. Clean engine fins, blower screen and
			air cleaner.
	2.	Using wrong weight oil.	2. See engine manual.
	3.	Too much oil in crankcase.	3. Drain excess oil.
Engine exhaust is black.	1.	Dirty air filter.	1. Replace air filter. See engine manual.
	2.	Engine choke control	2. Open choke control.
		is in closed position.

21