MOWER DECK LEVELING
ADJUSTMENTS
WARNING
Before inspecting or adjusting the mower, turn the mower blades OFF, turn the ignition switch OFF, and allow all moving parts to stop. Remove ignition key, then disconnect the spark plug wire and fasten it away from the spark plug.
Side to Side Leveling
If the cut is uneven, the mower may need leveling. Unequal or improper tire pressure may also cause an uneven cut. See CHECK TIRE PRESSURE.
1.With the mower installed, place the rider on a smooth, level surface such as a concrete floor. Turn the front wheels straight forward. Turn the engine off, set the ground speed control levers to PARK, and wait for all moving parts to stop.
2.Check for bent blades and replace if necessary.
3.Check the tire pressures. See CHECK TIRE PRESSURE.
4.Set the cutting height to mid position. Arrange the mower blades so that they are pointing from
5.Measure the distance between the tips of the outside blades and the ground (Figures 35 & 36). If there is more than 1/8" (3mm) difference between the measurements on each side, proceed to step 6. If the difference is 1/8" (3mm) or less, proceed to Front To Back Leveling.
6.See Figure 37.
(B) on the right and left rear sides of the mower deck. Loosen the jam nuts (C) and adjust the nuts up or down to adjust the mower level. When complete, tighten the jam nuts against the trunnion to lock the adjustment in place.
A
B
C
Figure 35. Measure Blade Tips to Ground
A.Mower Deck
B.Blade Tip
C.Level Ground
Figure 36. Orient Blades Side-to-Side
B
A
C |
Figure 37. Side-to-Side Adjustment
A.Threaded Rod
B.Trunnion
C.Jam Nuts
27
