ATTACHING A TRAILER

The maximum weight of a towed trailer should be less than 200 lbs (91kg). Secure the trailer with a appropriately sized clevis pin (A, Figure 10) and clip (B).

Excessive towed loads can cause loss of traction and loss of control on slopes. Reduce towed weight when operating on slopes. The surface being driven on greatly impacts traction and stability. Wet or slippery surfaces can greatly reduce traction and the ability to stop or turn. Carefully evaluate the surface conditions before operating the unit and trailer, and never operate on slopes greater than 10°. See SLOPE OPERATION and TOWED EQUIPMENT in the safety section of this manual for additional safety information.

Operation

A

B

Figure 10. Trailer Weight Recommendations

A.Clevis Pin

B.Clip

STORAGE

WARNING

Never store the unit (with fuel) in an enclosed, poorly ventilated structure. Fuel vapors can travel to an ignition source (such as a furnace, water heater, etc.) and cause an explosion.

Fuel vapor is also toxic to humans and animals.

Before toy store your unit for the off-season, read the Maintenance and Storage instructions in the Safety Rules section, then perform the following steps:

Disengage the PTO, set the parking brake, & remove the key.

Perform engine maintenance and storage measures listed in the engine owner’s manual. This includes draining the fuel system, or adding stabilizer to the fuel (do not store a fueled unit in an enclosed structure - see warning).

Battery life will be increased if it is removed, put in a cool, dry place and fully charged about once a month. If the battery is left in the unit, disconnect the negative cable.

Before starting the unit after is has been stored:

Check all fluid levels. Check all maintenance items.

Perform all recommended checks and procedures found in the engine owner’s manual.

Allow the engine to warm up for several minutes before use.

17

Page 21
Image 21
Simplicity CE Models, 5022285 instruction sheet Attaching a Trailer, Storage