MAINTENANCE SCHEDULE
MAINTENANCE REQUIRED
Check auger gear case lubrication.**
Lubricate snowth rower.
Check tire pressure.
Change engine oil.*+
Clean or replace spark plug.+
Check drive linkage/belt tension.
Lubricate Axle Shafts.
Check/Lubricate
Lubricate Auger Shaft. ***
*Change original oil after two hours of operation. **Check oil level each fall and spring.
***Lubricate each fall and spring.
4- See your engine Owner'sManual.
Regular
Maintenance
FREQUENCY |
| NOTES | |||
25 | Hours | Benalene | 900 | ||
| Grease | ||||
10 | Hours | 10W | Oil | and | Grease |
Monthly | 20 | psi | (1.37 bar) | ||
50 | Hours+ | See | Engine | Manual | |
Yearly | See | Engine | Manual | ||
Hours |
| N/A |
| ||
Yearly | Lithium | Grease | |||
10 | Hours |
| 10W Oil | ||
10 | Hours | Lithium | Grease |
CHECKING TIRE PRESSURE
The air pressure in each tire (Figure 11) should be 20 psi (1,36 kPa) and should be equal for both tires for best performance. Be sure to keep caps on valves to prevent entry of debris into the valve stem when tires are filled.
CHECK AUGER
GEAR CASE LUBRICATION
Figure 11. Checking Tire Pressure
1.Place the snowthrower on a level surface.
2.Remove the pipe plug (Figure 12).
3. | Check the lubricant level. It should be level with the | I |
| lower edge of the plug opening. If not, add Benalene |
|
| 900 grease (available from your dealer). |
|
4. |
|
Figure 12. Checking Auger Gear Case Lubrication
17