![](/images/new-backgrounds/1195887/19588731x1.webp)
Auger and Impeller Group - 24"
NOTE: Unless noted otherwise, | 985466 |
use the standard hardware torque specification chart.
4 |
Torque to 30
End of hub to be flush with end of rolled down
shaft (Ref. 9). | 1 |
2 |
14 | 16 |
|
17 |
18 |
11 |
10 |
10 |
5 |
10 | 7 | 6 |
9 | 8 |
2 |
| Torque to | |
3 | ||
24 - 28 Nm. | ||
|
15 |
19 |
6 |
12 |
13 |
Impeller to be positioned against bearing before tightening set screw.
Marked side of worm gear must contact against left thrust washer to assure proper gear mesh.
20 | 21 | 22 |
18 | 23 |
|
14 |
29 | 26 | 25 |
| 24 | |
|
|
Torque to 9 - 11
27
Auger assembly stamped "R".
Apply grease until
28it appears at ends of auger assembly (2 places).
Auger assembly stamped "L".
The above parts group applies to the following Mfg. Nos.:
1694439 - 960E
1694435 - 960M
© Copyright 2003 Simplicity Manufacturing, Inc. All Rights Reserved. | 16 | TP |