Intermediate Frame Snowthrowers
WARNING
Do not
Verify that the cables are not
If unit does not move forward freely, the cable has been
TRACTION DRIVE ADJUSTMENT
Initial Adjustment
1.With the drive lever released there should be slack in the cable when moved slightly from side to side.
2.To adjust tension on the cable slide the cable boot (A, Figure 4) off the cable adjustment bracket (D).
3.Move the “Z” hook (C) from the cable adjustment bracket (D) to a different adjustment hole. The cable should have slack. The cable should have no tension or load.
Note: If the cable is too slack the unit will not drive. If the cable is too tight the drive will be engaged without push- ing the handle down.
4.Slide the cable boot (A) over the cable adjustment bracket.
A |
BB
C
DC
Figure 4. Traction Drive Cable Adjustment
A.Cable Boot
B.Traction Drive Cable
C.“Z” Hook
D.Cable Adjustment Bracket
Run-In Adjustment
ALL MODELS
1.After 5 hours of use, check for proper adjustment. Readjust clutch cable if necessary by increasing ten- sion on cable. A small amount of arm movement is permissible if unit passes operating checks described in the Warning above.
WARNING
Gasoline is highly flammable and must be handled with care. Drain gasoline outdoors. Never drain the tank when the engine is still hot from recent operation. Do not allow open flame, smoking or matches in the area. Avoid
2.Remove the gas from the gas tank.
3.Disconnect the spark plug wire.
4.Stand snowthrower on the front of the auger housing (C, Figure 5).
5.Remove the capscrews (A) on each side of the bot- tom panel (B).
6.Remove the bottom panel (B).
A |
A |
C
B
Figure 5. Bottom Cover
A.Capscrews
B.Bottom Panel
C.Auger Housing
09/2007 | 13 | TP |