Ignition Switch
The ignition switch starts and stops the engine, it has three positions:
OFF | Stops the engine and shuts off the |
| electrical system. |
RUN | Allows the engine to run and powers the |
| electrical system. |
START | Cranks the engine for starting |
NOTE: Never leave the ignition switch in the RUN position with the engine
Throttle Control
The throttle controls engine speed. Move the throttle forward to increase engine speed and back to decrease engine speed. Always operate at FULL throttle
Ground Speed Control Levers
These levers control the ground speed of the rider. The left lever controls the left rear drive wheel and the right lever controls the right rear drive wheel.
Moving a lever forward increases the FORWARD speed of the associated wheel, and pulling back on a lever increases the REVERSE speed.
Note: The further a lever is moved away from the neutral position the faster the drive wheel will turn.
See the Operating the Zero Turn Rider section for steering instructions.
Hour Meter / Maintenance Reminder
Measures the time of the PTO being engaged. The hour meter measures the number of hours the PTO has been engaged. The hour meter will flash an initial oil change indicator at 5 hours, and a lubrication reminder every 50 hours. These reminders display for approximately two hours and will automatically reset themselves.
Note: The hour meter will register the passage of time only when the PTO is engaged. The hour meter has a self contained power source so the total hours are always visible.
Features and Controls
Seat Adjustment Lever
The seat can be adjusted forward and back. Move the lever towards the left, position the seat as desired, and release the lever to lock the seat in position.
Fuel Tank Cap
To remove the cap, turn counterclockwise.
Fuel Level Gauge
Displays the fuel level in the tank.
Retractable Seat Belt
The seat belt is used to secure the operator to the seat.
The seat belt should always be worn when using this equipment with a roll bar.
15
