1. DESCRIPTION OF THE MACHINE AND ITS OPERATION.
(See figure below)
The machine consists of the head, air hoses and pneumatic foot pedal.
The moving parts in the machine are located inside the head (pneumatic cylinder, manometer, axles, dies, etc.).
After placing the machine in its permanent location, without fitting the air hosepipe into the mouth of the compressor, verify that it has not suffered any blow or breakage while being transported and that it has not any loose parts.
The operation of the machine is very simple:
When pressing the pedal “C” a pneumatic safety cylinder “B” is activated. The safety cylinder causes the ring guard “E” to descend right to the point where it can check that there are not any fingers or hands in the grommeting area “D” and activates the micro end of race which sets the pneumatic cylinder “A” in motion.
The pneumatic cylinder “A” causes the vertical axles to descend. Attached to the lower part of the vertical axles are the top set spindle and the top die that does the grommeting.
The aim of the downward movement of the axles is to cause the
After this cycle the machine returns to its starting position ready for a new application as soon as you place the grommet and the washer and press the pedal “C”.
D 
C
A
B
E
3
