Singer 127-3 & 128-3 instruction manual Ruffler, On next

127-3 & 128-3

FIG. 26. THE RUFFLER AND ITS PARTS

Ruffler

Lines 1, 2, 3, 4 and .5 shown in Fig. 26 indi- cate where the material is to be placed for various operations, as follows:

Line 1	-- the correct position for the material
	to which the ruffled material is
	applied.
Line 2	-- material to be ruffled.
Line 3	-- the facing for the ruffle.
Line 4	-- the strip of piping material.

Line 5--the edge to be piped.

Refer to Fig. 26 when inserting the material in the ruffler.

The names and uses of the

principal parts of the ruffler are as fol-

lows:

(SEE: REFERENCES IN Fig. 26)

A -- FOOT -- the part by which the ruffler is attached to the presser bar.

B -- FORK ARM-- the section that must be placed astride the needle clamp.

C -- ADJUSTING SCREW -- the screw that regulates the fullness of the gather.

D -- PROJECTION -- the part that projects through tile the slots in the adjusting lever

E-- ADJUSTING LEVER -- the lever that sets the ruffler for gathering or for making a plait once at every six stitches or once at every twelve stitches, as desired: also for disengaging the ruffler, when either plaiting or gathering is not desired.

F -- ADJUSTING FINGER -- the part which regulates the width or size of the plaits.

continued on next page...

Table of Contents Previous Page Next Page

21