6.When replacing the needle clamp, make sure the needle bar is in its highest position. Insert the needle clamp into the needlebar, rotate and lightly push upward till the pin seats into the needle bar. Tighten the needle clamp screw clockwise with 1.5mm Allen wrench.
Note: Replace the clear fabric cover with needle guard and presser height adjusting screw before continuing to use the machine.
Replacing the light bulb
For safety reasons, unplug main power cord prior to replacing light bulb.
1.Make sure that the light bulb is completely cool before removing it from the machine.
2.Open lamp cover.
3.Remove the light bulb and replace new one with the same type rated, MAX 15W.
Cleaning the lint box
Slide the atbed extension to the left to remove it from the machine. Grasp the lint box by the ridged nger grips in the front and back and pull to the left to slide the lint box off the machine.
Clean the lint out after each project.
An accumulation of lint in the box or under the stitch plate may cause needle breakage.
Slide the lint box back into the machine.
10
34074 Singer ER10 Manual.indd 10
Groove 
(inside holder)
6/30/08 10:00:40 AM
