PS Engineering
Installation and Operator’s Manual
Figure 3-2 PMA8000-SR Operating controls
NOTE: Placing the
The intercom mode pushbutton determines who is on the phone, and who is still on the intercom.
In ISO, only the pilot is on the phone, while the copilot and passengers remain on intercom. The pilot will continue to hear all selected aircraft radios.
In the ALL mode, everyone will be on the phone, intercom, and hear aircraft radios, and:
In Crew mode, the pilot and copilot will be on the phone and hear aircraft radios, while the passengers will be on intercom.
3.3.1Swap Mode (Switch from Com 1 to Com 2 remotely)
With a yoke mounted, momentary switch, the pilot can change from the current Com transceiver to the other by depressing this switch. To cancel "Swap Mode," the pilot may either press the yoke mounted switch again, or select a different Com with the XMT buttons. .
3.4Audio Selector (4)
Receiver audio is selected through seven momentary,
The users can identify which receivers are selected by noting which of the green switch LEDs are lit. Push buttons labeled Nav 1, Nav 2, MKR (Marker), ADF and AUX (auxiliary) places those receivers into the audio stream. DME audio (if present) will come through when the AUX button is selected. When one of these buttons is pressed, the mode is active, and the LED will illuminate. Press the switch again and it will be "off" and remove that receiver from the audio output.
3.4.1Speaker Amplifier (5)
The "SPR" in the
Unswitched audio input 1, (the input dedicated to autopilot disconnect, altimeter warning, etc.) will come through the speaker regardless of the speaker button position. Unswitched audio input 2, (the input dedi- cated to a lesser importance input such as GPS waypoint alert) will come through the speaker only when the SPR mode is on. Consult your installer for more information.
3.4.1.1 Public Address Initialization
When shipped from the factory, the Public Address function is inhibited. To initialize the PA function, you must have the Sirius Remote Control. Press 3 0 0 on the keypad to initialize the PA function. You will
Page | Rev. 13, July 2006 |