Sirius Satellite Radio S50 manual Console Front Mount Method a

A.

B.

Figure 3

C.

Figure 4

Depending upon the mounting location you select in your vehicle, console front mount, con- sole side mount, or vent mount, the mount should be assembled as described in the following three sections. Each type of mount method should only be installed as depicted, i.e., the con- sole side mount method should only be used when installing to the side of the console, etc.

Console Front Mount Method (A)

To mount the car dock using the console front mount method, assemble the mount as follows, as shown in Figure 5:

1.Attach the adhesive foot to the mounting bracket, placing a collar in the bracket before screwing the foot to the arm. The side of the collar with the hole should face the foot.

2.Attach the car dock to the mounting bracket using the provided screws.

3.Before adhering the mount to the side of the console, be sure to select your mounting position carefully because once the mount has been adhered to a surface, it will not be possible to remove it and adhere it again.

4.Clean the selected mounting surface area in the vehicle with the alcohol swab.

5.Unscrew the adhesive foot from the mount. Peel the protective material off the adhesive on the foot and press the foot firmly against the vehicle surface.

6.The adhesive mount should then be allowed to adhere for a minimum of 2-4 hours before use. Best adhesion occurs after 24 hours. When the adhesive foot has achieved suf- ficient adhesion, reattach the remainder of the mount to the foot.

Adhesive	Mounting	Vehicle
Foot	Bracket	Dock
	Collar

Figure 5

14 [ Getting Started ] [ Getting Started ] 15