Skil 2372 manual Battery Disposal, Insulating tape to prevent shorting, LITHIUM-ION Batteries

SM 1619X03291 05-08 5/28/08 1:52 PM Page 7

Battery Disposal

Do not attempt to disas- ! WARNING semble the battery or remove any component projecting from the battery terminals. Fire or injury may result. Prior to disposal, protect exposed terminals with heavy

insulating tape to prevent shorting.

LITHIUM-ION BATTERIES

If equipped with a lithium-ion battery, the battery must be collected, recycled or disposed of in an environmentally sound manner.

“The EPA certified RBRC Battery Recycling Seal on the lithium-ion (Li-ion) battery indicates Robert Bosch Tool Corporation is voluntarily participating in an industry

program to collect and recycle these batteries at the end of their useful life, when taken out of service in the United States or Canada. The RBRC program provides a convenient alterative to placing used Li-ion batteries into the trash or the municipal waste stream, which may be illegal in your area.

Please call 1-800-8-BATTERY for information on Li-ion battery recycling and disposal bans/restrictions in your area, or return your batteries to a Skil/Bosch/Dremel Service Center for recycling. Robert Bosch Tool Corporation’s involvement in this program is part of our commitment to preserving our environment and conserving our natural resources.”

Battery Disposal – 2362

BATTERY REMOVAL INSTRUCTIONS

!Run motor until battery is CAUTION completely discharged before

attempting to remove battery from your tool.

1.Remove the seven (7) housing screws with a flat blade screwdriver.

2.Remove housing cover by lifting upward from front end of tool.

3.Disconnect lead wires from switch.

4.Wrap heavy insulating tape around battery terminals or enclose in a sealable plastic bag to prevent possible shorting.

5.Dispose of battery through your local waste removal authority or a Skil Service Center.

Battery Disposal – 2372

BATTERY REMOVAL INSTRUCTIONS

!Run motor until battery is CAUTION completely discharged before

attempting to remove battery from your tool.

1.Loosen the nut with a large wrench in direction of arrow (A) and completely unthread nut.

2.Remove head assembly and nut from the tool.

3.Pull and remove metal front end in direction of arrow (B) to expose and remove the two T6 torx head screws.

4.Remove the six (6) housing screws with a flat blade screwdriver.

5.Remove housing cover by lifting upward from front end of tool.

6.Remove lead wires from switch.

7.Wrap heavy insulating tape around battery

terminals or enclose in a sealable plastic bag to prevent possible shorting.

8.Dispose of battery through your local waste removal authority or a Skil Service Center.

FIG. 2

HEAD ASSEMBLY

ARROW (A)

NUT

METAL FRONT END

ARROW (B)

T6 TORX HEAD

SCREW

-7-