Operating Instructions

BM 1619X01525 06-06 6/14/06 11:30 AM Page 9

The Skil model 2410 Cordless Drill/Driver has a collet that accepts only standard 1/4” hexagonal shank accessories with power groove. The low RPM capability of this model is not a deficiency. On the contrary, low speed means high torque and high torque is a definite plus for efficient drilling and driving. The low speed also provides more control to prevent stripout of the screw and damage to the work surface.

INSERTING AND REMOVING

ACCESSORIES

!WARNING To avoid loss of control, ensure bit is locked in chuck

by pulling on bit after it has been inserted.

Your tool is equipped with a quick release chuck. To insert an accessory, simply pull locking sleeve forward, insert desired accessory into chuck and release locking sleeve (Fig. 2).

To remove an accessory, pull locking sleeve forward and simply remove it from the chuck.

One inch bits should only be used along with a bit holder as shown in figure 2.

FIG. 2	LOCKING
	SLEEVE
	CHUCK

HEX-SHANK

DRILL BIT

SCREWDRIVER

BIT

BIT HOLDER

VARIABLE SPEED CONTROLLED

TRIGGER SWITCH

Your tool is equipped with a variable speed trigger switch. The tool can be turned "ON" or "OFF" by squeezing or releasing the trigger. The speed can be adjusted from the minimum to maximum nameplate RPM by the pressure you apply to the trigger. Apply more pressure to increase the speed and release pressure to decrease speed (Fig. 1).

FORWARD/REVERSING

LEVER & TRIGGER LOCK

!WARNING After tool use, lock trigger in “OFF” position to help prevent

accidental starts and accidental discharge.

Your tool is equipped with a forward/ reversing lever and trigger lock located above

the trigger (Fig. 1). This lever was designed for changing rotation of the bit, and for locking the trigger in an “OFF” position.

FORWARD/REVERSE INDICATOR LIGHTS Your tool is equipped with lights which indicate the rotation of the bit.

For forward rotation, (with bit pointed away from you) move the lever to the far left and a green indicator light depicting a forward arrow will light up.

For reverse rotation move the lever to the far right and the green indicator light depicting a reverse arrow will light up.

To stop in either direction just release the trigger. To activate trigger lock move lever to the center off position (Fig. 1).

ADJUSTABLE CLUTCH

Your tool features 10 clutch settings. Output torque will increase when the torque adjustment dial is rotated clockwise, and will decrease when the dial is rotated counter- clockwise. When the dial is set to the correct setting, the tool will stop when the desired torque has been reached.

The Drill “ ” position will lock up the clutch to permit drilling and driving heavyduty work (Fig. 3).