SM 2610957110
Assembly and adjustments
Mounting belt and disc sander to
workbench (Fig. 13)
If belt and disc sander is to be used in a permanent location, it should be fastened securely to a firm supporting surface such as a workbench.
If mounting to a workbench, holes should be drilled through supporting surface of the workbench.
1.The unit should be bolted securely using M8 screws and hex nuts (not included). Screw length should be 38mm plus the thickness of the bench top.
2.Locate and mark the holes where belt and disc sander is to be mounted.
3.Drill (2) x 9.5 mm diameter holes though workbench.
4.Place belt and disc Sander on workbench aligning holes drilled in workbench.
5.Insert two M8 screws and tighten hex nuts.
FIG. 13 |
13.