SM 2610947884
Sanding Accessories Assembly
BACKING PAD
!Before attaching a backing WARNING pad be sure its maximum
safe operating speed is not exceeded by the nameplate speed of the tool.
!WARNING Wheel guard may not be used for most sanding
operations. Always reinstall wheel guard when converting back to grinding operations.
TO INSTALL BACKING PAD AND
SANDING DISC
Disconnect tool from power source. Set the tool on its top side (spindle up). Place the rubber backing pad onto the spindle shaft. Center the sanding disc on top of the backing pad. Insert the lock nut through the disc and thread onto the spindle as far as you can with your fingers. Press in the spindle lock, then tighten the backing pad securely with lock nut wrench (Fig. 4).
TO REMOVE BACKING PAD AND
SANDING DISC
Disconnect tool from power source. Using the lock nut wrench unscrew the nut from the spindle, while holding spindle lock in.
WIRE BRUSH ASSEMBLY
Before assembling wire brush to this tool, disconnect from the power source. Wire
brushes are equipped with their own threaded hub, simply thread on to spindle. Be sure to seat against shoulder before turning tool “ON”.
FIG. 4
SPINDLE
BACKING
PAD
SANDING
DISC
LOCK NUT
WIRE BRUSH
Operating Instructions
SLIDE ON-OFF SWITCHES
The tool is switched “ON” by either the front or rear switch located on the top of the tool. The rear switch can be locked in the “ON” position, a convenience for long grinding operations. The front switch does not have the lock “ON” feature.
TO TURN THE TOOL “ON” without locking it, slide either switch button forward. When pressure is released the switch button will snap to “OFF” position.
TO LOCK THE REAR SWITCH “ON” slide the switch button forward and press “IN” the FRONT portion.
TO UNLOCK THE SWITCH USING THE REAR SWITCH, depress the REAR portion of the switch and release.
TO UNLOCK THE SWITCH USING THE FRONT SWITCH, SIMPLY PRESS
FORWARD AND RELEASE THE FRONT SWITCH.
!WARNING Be aware of the location and setting of the switch
buttons. If the switch is locked "ON" during the use, be ready for emergency situations to switch it "OFF".
FIG. 5REAR SWITCH BUTTON
FRONT
SWITCH BUTTON
