Fcc, Warranty, Customer Service, Additional Transmitter

6. BATTERY

12 volt alkaline battery (size 23A) (included).

It is time to change the battery when the red LED on the trans- mitter does not turn on when either button is pressed.

2 Press and hold the learn button on the left hand side of the receiver when plugging the receiver into an electrical socket, the red LED on the receiver will flash rapidly. All the transmitters are deleted.

Unplug the receiver from the electrical socket.

5. REMOVE TRANSMITTER FROM THE RECEIVER

You can delete the transmitter from a receiver.

The receiver red LED will go off indicates the programming is completed.

4. PROGRAM A TRANSMITTER TO THE RECEIVER

The transmitter in this kit has been programmed to the receiver in the factory. You need to do the programming only if you add additional transmitters to the receiver.

Learn

Button

1 Plug the receiver into an electrical socket.

2 Press and hold the learn button on the left hand side of the receiver. The red LED on the receiver will flash.

3 Press the button of the transmitter you want to program to the receiver.

9. FCC

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1)This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.

WARNING:

Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTE:

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does causeharmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

-Consult the dealer or an experienced radio/TV technician for help.

10. WARRANTY

If, within one year from date of purchase, this product should become defective (except battery), due to faulty workmanship or materials, it will be repaired or replaced, without charge. Proof of purchase and a Return Authorization are required.

11. CUSTOMER SERVICE

If you would like to order Skylink’s products or have difficulty getting them to work, please :

1.visit our FAQ website at www.skylinkhome.com , or

2.email us at support@skylinkhome.com , or

3.call our toll free at 1-800-304-1187 from Monday to Friday, 9 am to 5 pm EST. Fax (800) 286-1320

+ _

7. ADDITIONAL TRANSMITTER

You can add up to 15 transmitters as you want to control the same receiver. Simply program the transmitters to the receiver.

8. CAUTION

RISK OF ELECTRICAL SHOCK. FOR INDOOR USE ONLY.

CAUTION : DISCONNECT POWER BEFORE SERVICING.

Maximum Rating:

Input : 120VAC 60Hz 2W

CUSTOMER SERVICE

17 Sheard Avenue, Brampton, Ontario, Canada L6Y 1J3 Email:support@skylinkhome.com http://www.skylinkhome.com

P/N. 101A367

SkyLink MT-18 manual Fcc, Warranty, Customer Service, Additional Transmitter, Caution

Models: MT-18