SkyLink R4G manual Display Menu

							3. OPERATION (CONT)
Delete Remote Control
Delete the remote control(s) from the memory location, e.g. 123.
Display		1	2	3			Display
DEL ->	->				-> DEL	->	-> DEL -> If hear 3 beeps, confirmed the memory
Press					Press		location [123] is deleted.
			Press				Press

Press DISP twice to exit or enter another memory location to delete.

Block Remote Control (Inactivate)

This is to temporary disable specific remote control(s) from the memory location, e.g. 123.

Display	-> 1 2	3 -> ACT ->	Display
ACT ->			->
Press	Press	Press

ACT -> If hear 3 beeps, confirmed the memory

location [123] is blocked.

Press

Press DISP twice to exit or enter another memory location to block.

If a signal from a blocked remote is received, the receiver will sound a long beep and the memory location will be displayed. But the relay will not be activated.

Unblock Remote Control (Activate)
This is to reactivate the blocked remote control(s), e.g. 123.
ACT		Display	1	2	3 ->	ACT ->		Display	ACT
	->	->						->		->
Press				Press		Press			Press
Press	DISP twice to exit or enter another memory location to unblock.
Add Remote Control to designated location
Add the remote control(s) to the memory location you want to add a remote, e.g. 123.
		Display	1	2	3 ->	ADD		Display
ADD	->	->					->	->	ADD	->
Press				Press		Press			Press
The display will then show the next available memory location.
Press	DISP twice to exit or add another remote by pressing ADD							again.

If hear 3 beeps, confirmed the memory location [123] is unblocked.

If hear 3 beeps, confirmed the Remote is programmed to the memory location [123].

Display Menu

[DISP] [1] – Display status for all memory locations [DISP] [2] – Occupied memory locations

[DISP] [3] – Empty memory locations [DISP] [5] – Unblocked memory locations

After entering the specific display menu, the display can be shown by scrolling down with the key to show all the related memory locations. Example: To show all occupied memory locations

Display

DISP ->	-> 2 ->	-> (all the occupied memory locations will be shown, all with the occupied LED on)
Press	Press	Press

You can also display a specific memory location by entering the memory location number in any on of the display sub-menu. Example: You want to check memory location 123 to see if it is occupied, but you are in the blocked sub-menu, i.e. [DISP][4]

	Display	4		Display		1	2	3
DISP ->	->		->		->
Press		Press					Press

You can check whether the blocked LED is ON or not, occupied LED will also show whether this memory location is occupied or not.

–2–