Skyworth SLC-1963A-1 owner manual Installation, Television Location

INSTALLATION

Installation

Television Location

Follow these recommendations before deciding the

location of your television.

Avoid excessive sunlight or bright lights, including reflections.

Keep away from excessive heat or moisture. Inadequate ventilation may cause internal component failure.

Fluorescent lighting may reduce remote control transmitting range.

Keep away from magnetic equipment, including motors, fans and external speakers.

WARNING: Use this television receiver only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the Cart / apparatus combination to avoid injury from tip-over. In order to avoid injury to children, never place your television receiver on a piece of furniture that is capable of being tilted by a child leaning on it, pulling on it, standing o it, or climbing on it. A falling television can cause serious injury or even death.

Remote Control Battery Installation

Requires two AAA batteries(supplied).

Procedure

1.Turn the remote control face down. Remove battery cover by pressing down on the marking on the cover and sliding it off in the direction indicated.

2.Install batteries matching(+) and(-) polarity signs.

3.Replace the battery cover by sliding in reverse until the lock snaps.

Note: Incorrect installation can cause battery leakage and corrosion that will damage the Remote control.

Precautions

Replace batteries in pair.

Do not mix battery types(zinc carbon with alkaline).

Do not recharge, heat, short-circuit, disassemble, or burn batteries.

POWER SOURCE

TO USE AC POWER SOURCE

Use the AC /DV adaptor provided for operation on AC. Insert the AC cord plug into a standard 110-120V 60HZ polarized AC outlet.

AC outlet

Wider Hole

and Blade

Polarized AC Cord Plug (One blade is wider than the other)

To use Car cord

Use the Car Cord provided for operation on 12V DC.

NOTE:

1.AC/ DC adaptor provided can be connected to the specified voltage (AC 110 volts 60HZ).

2.If the polarized AC cord does not fit into a non-

polarized AC outlet, do not attempt to file or cut

,

the blade. It is the user s responsibility to have an electrician replace the obsolete outlet.

3.If you cause a static discharge when touching the unit, and the unit fails to function, simply unplug the unit from the AC outlet, wait a few minutes, and plug it back in. The unit should return to normal operation.

5