SLS Audio HT805C, HT805S, HT805W, HT805T owner manual Page, Audio Connection cont

HT805 Series Owner’s Manual

Page 7

Audio Connection (cont.)

The HT805W subwoofer will accept both line level signals via RCA jacks or speaker level signals from an amplifier via the binding posts. Do not use a mixture of line level and speaker level connections. Whenever possible, use the line level connections.

Use of the Full Range setting uses your receiver - proces- sor to control the crossover point between the subwoofer and satellites. Alternatively, use the Low Pass when connected to a normal stereo output or when your receiver - processor settings give unsatifactory results. Low Pass will engage the crossover knob for high frequency cut-off adjustment (typically set around 80Hz when used with the HT Series Satellites)

Power switch for subwoofer

“On” will always apply power,“Auto” will engage the sense circuit turning off the subwoofer when no signal is present after a period of about 5 mins. When signal is present at the inputs, the subwoofer will automatically turn on.

Continuously variable phase control. Adjustments can provide a better blend between the subwoofer and satellites when they are remotely located from each other.

Fuse Holder

Unaltered pass-through output signal (exactly matches input signal) Used for optional additional subwoofers or in the case of a line level stereo output, they would go to the input of the amplifer for the satellites

Input received from dedicated subwoofer output on source electronics or a line level normal stereo output. A dedicated subwoofer output can use either the left or right inputs.

Volume adjustment of subwoofer used to blend in with the satellites

Alternate input (from amplifier powering stereo pair of speakers)

80Hz high pass filtered output signal (goes directly to satellite speakers)

Line Voltage Selector Switch

Rev: 602 1650 W. Jackson Ozark, MO 65721 (417) 883-4549